Two-body, three vessel red copper brewhouse finished production
One set of 800L red copper two vessel beer brewery system finished production in our workshop recently. The luxury exterior shell makes the brewhouse looks shiny and attractive.
The structure of the brewhouse based on special stacked two vessel, just mean a combined vessel of mash/lauter tun on top, a whirlpool tun on bottom; And a separate vessel of brew kettle which can also be used as HLT.
(1). As you know for electric heating, there will be electric heating coil inside of the brew kettle. Which may effect whirlpooling.But this structure, the brew kettle is one separated tank, so the whirlpooling will not be influenced.
(2). It is available to do lautering by gravity. As the whirlpool tun was under the mash/lauter tun, so the wort could be lautered by gravity to the whirlpool tun.The whirlpool tun is used as a buffer tank. But the luatering speed will be slow I think.
(3). Two body-three vessel brewhouse can achieve fly sparging. Just mean you can do lautering and sparging at the same time.
(4). Compared with the common two vessel Mash/lauter tun + Kettle/whirlpool + HLT. This structure with a little lower cost and need smaller footprint.
But there are also some limits of this structure.As the whirlpool tun was under the mash/lauter tun, so the total height of the brewhouse is much higher than the common two vessel.
It is not suitable if you have a limited ceiling height.
Welcome to contact us if you also have any special requirements about the brewhouse structure.
Request A Quote